|
|
|
|
1-port DIN rail serial Industrial Gateway (RS-232/422/485) with a screw terminal connector and a single Ethernet port. The DeviceMaster EIP-MOD provides EtherNet/IP to Modbus, Modbus to EtherNet/IP, and Modbus to Modbus communication. Combining flexible EtherNet/IP interfaces, advanced Modbus gateway and routing capabilities, a Data Mapping sub-system and a built-in Modbus concentrator, the EIP-MOD gateway provides unmatched capabilities.
Hardware
- Interface Specification10/100BASE-T Ethernet
- Memory
- EnclosureUL94-V0 PLASTIC
- Installation MethodDIN Rail (35mm)
- LED IndicatorsStatus, Ethernet Port Link and Activity
- Dimensions4.7” x 3.9” x 0.9”
119.3 x 99.1 x 22.86mm
- Product Weight0.25 lbs
113.4 g
Electrical Specifications
- Device
- Input Voltage Requirements5-30VDC
- Power Consumption (Max.)1.5 Watts
- Power Input RedundancyDual Redundant Power Input
- ESD Surge ProtectionProvides minimum of 25KV protection for all serial lines. All Ethernet components are rated to 1.5KV magnetic surge protection.
Environmental Specifications
- Air temperature
- System On-40 to 75° C
- System Off-40 to 85° C
- Operating Humidity (non-condensing)0% to 95%
- Altitude0 to 10,000 Feet
3,048 m
- MTBF (Mean Time Between Failures)61.4 Years
Serial Communications
- Number of Ports1
- Connector Type9-Pin Screw Terminal Block
- Software Selectable InterfacesRS-232
RS-422
RS-485 4-wire, Master
RS-485 4-wire, Slave
RS-485 2-wire
- Termination Resistor for RS232/485Software controllable 120Ω termination resistors available for each transmit and receive differential pair on every port. The 120Ω termination resistors can be enabled between TX+ and TX- OR RX+ and RX- or both on every port
- Baud Rate300 bps to 230.4Kbps
- Receive Buffer4.5KB
- Transmit Buffer4.5KB
- Serial Data Control
- Data Bits5, 6, 7 or 8
- ParityOdd, Even, Mark, Space, or None
- Stop Bits1, 1.5, or 2
- Flow ControlHardware, Software, or None
Ethernet Specifications
- Number of Ports1
- Speed10/100Mbps
- Connector TypeRJ45F Auto MDI/MDI-X
- LEDEthernet Link (Green)
Ethernet Activity (Amber)
- Ethernet specific featuresEthernet packet switching, Auto Negotiation, Link/Activity Status LED
- Network ProtocolsARP, BOOTP, DHCP/RARP, HTTP, HTTPS, SSH, SSL/TLS, ICMP, RFC 1006 (ISO over TCP), SNMP (MIB-II), TCP/IP & UDP socket services, Telnet, and TFTP, and supports IP multicast data transmission
EtherNet/IP Features
- Supported PLCsIncluding but not limited to:
Allen Bradley: ControlLogix, CompactLogix, FlexLogix, SoftLogix, SLC 5/05, PLC-5, and MicroLogix Models
- Web PagesConfiguration – Serial device interfaces, Network, EtherNet/IP stack, Modbus TCP, Modbus over Ethernet TCP/IP, Remote Modbus devices, Modbus Alias, Data Mapping, Shared Memory, Security
Informational – Data Mapping Verification, Shared Memory Map, EtherNet/IP Class 1 Interface
Diagnostics – Serial statistics and logs, EtherNet/IP and Modbus TCP diagnostics, Modbus slave devices, Modbus over TCP/IP statistics, Modbus Alias, Data Mapping statistics, Shared Memory contents/statistics, System log
System – Update firmware, Configuration file save/load, System Snapshot, Restore Defaults
- DiagnosticsYes
- Electronic Data Sheets (EDS)Yes
- Sample PLC ProgramsYes
Features
- SNMP SupportMONITORING ONLY
- Other Software FeaturesPortVision DX remote management
Save/Load configuration files
- Manufacturer's Warranty5 Years
Export Information
- Packaged Shipping Weight0.60lbs
272g
- Package Dimensions5.68” x 5.68” x 3.37”
144.46 x 144.46 x 85.73mm
- UPC Code7-56727-99627-9
- Country of OriginUSA
- ECCN5A992
- Schedule B Number8471.80.1000
Regulatory Approvals
- EmissionsCanadian EMC Requirements
ICES-003
European Standard EN55022
FCC PART 15 SUBPART B: CLASS A LIMIT
AS/NZS CISPR 22
- ImmunityEuropean Standard EN61000-6-2
European Standard EN55024
IEC 1000-4-2/EN61000-4-2: ESD
IEC 1000-4-3/EN61000-4-3: RF
IEC 1000-4-4/EN61000-4-4: FAST TRANSIENT/BURST
IEC 1000-4-5/EN61000-4-5: SURGE
IEC 1000-4-6/EN61000-4-6: CONDUCTED DISTURBANCE
IEC 1000-4-8/EN61000-4-8: MAGNETIC FIELD
IEC 1000-4-11/EN61000-4-11: DIPS AND VOLTAGE VARIATIONS
- SafetyIUL 61010-1, UL 61010-2-201
CSA C22.2 No. 61010-1-12
CSA C22.2 No. 61010-2-201:14
- OtherEuropean Standard: 2002/95/EC Directive (RoHS)
NEMA TS2 Compliant
ODVA Certification
- Other Regulatory Approvals
Pinout Diagrams
- Ground must be connected to the signal ground terminal.
|
|
|
|
|
|
|
|
|
|
|
|
|
Features
- DIN rail mountable
- One screw terminal serial port (RS-232/422/485) with a minimum of 25KV of surge protection
- Variable power input – 5-30VDC with a screw terminal connector
- One RJ45 Ethernet port
- Provide PLC connectivity – to standard EtherNet/IP™ serial devices
- Wide industrial operating temperature range (-40° to 75°C)
- Software Controllable integrated 120Ω Termination Resistor for both the Transmit and Receive side in RS-422/485 Mode
- PortVision DX – configure network settings for the DeviceMaster and monitor status, update firmware and if necessary, resolve issues remotely
- Security features – SSL & SSH management
|
|
|
|
|
|
|